HP ProCurve 5400zl

bootp-gateway
■ [no] interface vlan VLAN-ID ip bootp-gateway
Usage: [no] ip bootp-gateway [IP-ADDR]
Description: Add or remove the gateway address to be used for stamping
incoming DHCP requests.
This is a VLAN context command. It can be called directly
from the VLAN context or follow the 'vlan VLAN-ID'
command.
Next Available Option:
■ ip-addr -- IPv4 address of the BOOTP gateway. (IP-ADDR) (p. 241)
broadcast-limit
■ interface [ETHERNET] PORT-LIST broadcast-limit < 0 to 99 >
Usage: broadcast-limit <0-99>
Description: Set a broadcast trafc percentage limit.
This command sets the theoretical maximum of network
bandwidth in percentage that can be used for broadcast
trafc. Any broadcast trafc exceeding that limit will be
dropped. '0' means the feature is disabled.
For 1000 Mbps and higher speed ports, the percentage of broadcast
trafc congured is that percentage applied to the theoretical
maximum broadcast throughput for a 100 Mbps port. This is to
allow ner resolution of control for high-speed links.
This is an Interface context command. It can be called directly
from the interface context or follow the 'interface [ethernet]
PORT-LIST' command.
Range: < 0 to 99 >
chain-name
■ interface vlan VLAN-ID ip ospf md5-auth-key-chain CHAIN-NAME
Specify key chain to use for MD5 authentication.
■ interface vlan VLAN-ID ip ospf IP-ADDR md5-auth-key-chain CHAIN-NAME
Specify key chain to use for MD5 authentication.
■ interface vlan VLAN-ID ip ospf all md5-auth-key-chain CHAIN-NAME
Specify key chain to use for MD5 authentication.
connection-rate-filter
■ interface vlan VLAN-ID connection-rate-filter
Usage: connection-rate-lter unblock < host SRC-IP-ADDR | SRC-IP-ADDRESS/mask
>
[no] connection-rate-lter sensitivity <low|medium|high|aggressive>
Description: Re-enables access to a host or set of hosts that has been previously
blocked by the connection rate lter. Disabling or setting sensitivity
228© 2009 Hewlett-Packard Development Company, L.P.
interfaceCommand Line Interface Reference Guide