HP ProCurve 5400zl

priority.
If no guaranteed minimum bandwidth is congured (i.e., the
settings for all queues are 0), the trafc is serviced
strictly by priority. In practice, this may cause complete
starvation of some or all lower-priority queues during any
periods where the output port trafc is over-subscribed.
This is an Interface context command. It can be called directly
from the interface context, or following the
'interface [ethernet] PORT-LIST' command.
Next Available Option:
■ output -- Enable/disable and configure guaranteed minimum bandwidth for outgoing traffic.(p.
258)
bcast
■ [no] interface [ETHERNET] PORT-LIST rate-limit bcast
Set limits for broadcast trafc.
Next Available Option:
■ in -- Set limits for inbound broadcast trafic.(p. 238)
binary-range
■ interface [ETHERNET] PORT-LIST qos dscp < 0 to 63 >
Specify the DSCP code-point in binary.
Range: < 0 to 63 >
■ interface vlan VLAN-ID qos dscp < 0 to 63 >
Specify the DSCP code-point in binary.
Range: < 0 to 63 >
■ interface svlan VLAN-ID qos dscp < 0 to 63 >
Specify the DSCP code-point in binary.
Range: < 0 to 63 >
blocked
■ interface vlan VLAN-ID ip igmp blocked [ETHERNET] PORT-LIST
Usage: ip igmp blocked [ethernet] PORT-LIST
Description: Instruct the device to drop incoming multicast packets
received on the specied ports. This feature is
congured on a per-VLAN basis.
■ interface vlan VLAN-ID ipv6 mld blocked [ETHERNET] PORT-LIST
Usage: vlan < vid > ipv6 mld blocked < port-list >
Description: Instruct the device to drop incoming multicast packets
received on the specied ports. This feature is
congured on a per-VLAN basis.
227© 2009 Hewlett-Packard Development Company, L.P.
interfaceCommand Line Interface Reference Guide