leaveall-timer
■ interface [ETHERNET] PORT-LIST gvrp leaveall-timer < 500 to 3000 >
Set leaveall timer value (centiseconds; default 1000).
Range: < 500 to 3000 >
leave-timer
■ interface [ETHERNET] PORT-LIST gvrp leave-timer < 40 to 300 >
Set leave timer value (centiseconds; default 300).
Range: < 40 to 300 >
link-keepalive
■ [no] interface [ETHERNET] PORT-LIST link-keepalive
Usage: [no]link-keepalive [vlan <vlan-id>]
Description: Congure UDLD on port(s).
The command enables/disables UDLD on particular port/port-list
By default UDLD control packets are untagged.
The user has to give vlan-id for tagged UDLD control packets.
Next Available Option:
■ vlan -- Set vlan-id for tagged UDLD control packets. (VLAN-ID) (p. 282)
link-local
■ [no] interface vlan VLAN-ID ipv6 address IPV6-ADDR link-local
Congure a link-local IPv6 address.
■ [no] interface svlan VLAN-ID ipv6 address IPV6-ADDR link-local
Congure a link-local IPv6 address.
local-proxy-arp
■ [no] interface vlan VLAN-ID ip local-proxy-arp
Usage: [no] ip local-proxy-arp
Description: Enable/disable local proxy ARP. This is a VLAN context command.
It can be called directly from the VLAN context or may follow
the 'vlan VLAN-ID' command prex. When local proxy ARP is
enabled on a VLAN, the device responds to all ARP requests
received on the VLAN ports with it's own hardware address.
loopback
■ [no] interface loopback < 0 to 7 >
Usage: [no] interface loopback <num>
Description: Enter the loopback Conguration Level.
Range: < 0 to 7 >
248© 2009 Hewlett-Packard Development Company, L.P.
interfaceCommand Line Interface Reference Guide
To Next Page
Loading...
