â– ipv6-addr/mask -- Configure IPv6 address represented in CIDR notation.
(IPV6-ADDR/PREFIX-LEN) (p. 245)
advert-address
â– interface vlan VLAN-ID ip irdp < multicast | broadcast >
Usage: [no] ip irdp <multicast|broadcast>
Description: Specify the destination address to be used for router
advertisements.
It has to be either multicast or broadcast. If the value
of this object is 'multicast' (the default), router
advertisements will be sent to the all-hosts multicast
address, 224.0.0.1. If the value of this object is 'broadcast',
router advertisements sent on this interface will be sent to
the limitied broadcast address, 255.255.255.255.
Supported Values:
â– multicast -- Send advertisements to all-hosts multicast address.
â– broadcast -- Send advertisements to broadcast address.
advertise-interval
â– interface vlan VLAN-ID vrrp vrid < 1 to 255 > advertise-interval < 1 to 255 >
Usage: vrrp vrid <VRID> advertise-interval <1-255>
Description: Set time interval (in seconds) between sending VRRP advertisement
messages. The default value is one second.
Range: < 1 to 255 >
all
â– [no] interface [ETHERNET] PORT-LIST monitor all < In | Out | Both >
Monitor all trafîš¿c.
Supported Values:
â– In -- Monitor all inbound traffic
â– Out -- Monitor all outbound traffic
â– Both -- Monitor all inbound and outbound traffic
Next Available Option:
â– mirror -- Mirror destination.(p. 251)
â– [no] interface [ETHERNET] PORT-LIST rate-limit all
Set limits for all trafîš¿c.
Next Available Options:
â– in -- Set limits for all inbound traffic.(p. 238)
â– out -- Set limits for all outbound traffic.(p. 257)
â– [no] interface loopback < 0 to 7 > ip ospf all
219© 2009 Hewlett-Packard Development Company, L.P.
interfaceCommand Line Interface Reference Guide
To Next Page
Loading...
Need help?
General