HP ProCurve 5400zl User Manual

Process the request for all IP addresses.
Next Available Options:
■ area -- Specify an OSPF area.(p. 221)
■ cost < 1 to 65535 > -- Set metric of this interface.(p. 229)
■ [no] interface vlan VLAN-ID ip ospf all
Process the request for all IP addresses.
Next Available Options:
■ passive -- Configures an ospf interface as passive. (p. 258)
■ area -- Specify an OSPF area.(p. 221)
■ authentication-key -- Set simple authentication method and key.(p. 223)
■ authentication -- Disable authentication.(p. 223)
■ md5-auth-key-chain -- Set MD5 authentication method and key chain.(p. 250)
■ cost < 1 to 65535 > -- Set metric of this interface.(p. 229)
■ dead-interval < 1 to 65535 > -- Set dead interval in seconds; the default is 40.(p. 229)
■ hello-interval < 1 to 65535 > -- Set hello interval in seconds; the default is 10.(p. 236)
■ priority < 0 to 255 > -- Set priority of this router as a designated router.(p. 265)
■ retransmit-interval < 1 to 3600 > -- Set retransmit interval in seconds; the default is 5.(p. 273)
■ transit-delay < 1 to 3600 > -- Set transit delay in seconds; the default is 1.(p. 279)
■ [no] interface vlan VLAN-ID ip rip all
Process the request for all IP addresses.
Next Available Options:
■ authentication-type < none | text > -- Set authentication type used on this interface.(p. 224)
■ authentication-key -- Set RIP authentication key (maximum 16 characters).(p. 223)
■ metric < 1 to 15 > -- Set metric for this interface.(p. 250)
■ poison-reverse -- Enable/disable poison reverse on this interface.(p. 262)
■ receive < V1-only | V2-only | V1-or-V2 | ... > -- Define RIP version for incoming packets.(p. 273)
■ send < disabled | V1-only | V1-compatible-V2 | ... > -- Define RIP version for outgoing packets.(p.
275)
■ rip-compatible < V1-only | V2-only | V1-or-V2 > -- Define RIP version for incoming and outgoing
packets.(p. 274)
■ interface vlan VLAN-ID connection-rate-filter unblock all
Resets all previously blocked by the connection rate lter
■ interface vlan VLAN-ID monitor all < In | Out | Both >
Monitor all trafc.
Supported Values:
■ In -- Monitor all inbound traffic
■ Out -- Monitor all outbound traffic
■ Both -- Monitor all inbound and outbound traffic
Next Available Option:
■ mirror -- Mirror destination.(p. 251)
220© 2009 Hewlett-Packard Development Company, L.P.
interfaceCommand Line Interface Reference Guide

HP ProCurve 5400zl Specifications

General

Brand	HP
Model	ProCurve 5400zl
Category	Switch
Language	English