HP ProCurve 5400zl

'0.0.0.0') the virtual router uses numerically lowest IP address
of the VLAN. The default value is 'lowest'.
Next Available Options:
■ ip-addr -- Specify IP address. (IP-ADDR) (p. 241)
■ lowest -- Dynamically determine lowest IP address.(p. 249)
priority
■ interface [ETHERNET] PORT-LIST power-over-ethernet < critical | high | low >
Usage: [no] power-over-ethernet [critical|high|low]
Description: Enable/Disable per-port power distribution. Specifying critical,
high, or low indicates the priority of the port to get power in
the event of power over-subscription. Per-port power is enabled
by default. The default priority is low.
Note: Lower numbered ports have precedence over higher numbered
ports of the same priority.
Supported Values:
■ critical
■ high
■ low
■ interface [ETHERNET] PORT-LIST qos priority < 0 | 1 | 2 | ... >
Specify priority to use.
Supported Values:
■ 0
■ 1
■ 2
■ 3
■ 4
■ 5
■ 6
■ 7
■ interface vlan VLAN-ID ip ospf priority < 0 to 255 >
Set priority of this router as a designated router.
Range: < 0 to 255 >
■ interface vlan VLAN-ID ip ospf IP-ADDR priority < 0 to 255 >
Set priority of this router as a designated router.
Range: < 0 to 255 >
■ interface vlan VLAN-ID ip ospf all priority < 0 to 255 >
Set priority of this router as a designated router.
Range: < 0 to 255 >
■ interface vlan VLAN-ID qos priority < 0 | 1 | 2 | ... >
Specify priority to use.
Supported Values:
265© 2009 Hewlett-Packard Development Company, L.P.
interfaceCommand Line Interface Reference Guide