1. Rack Brackets
2. Flat head Screws
6.5.
1. Install the retainer horizontally1. Pan Head Screw
2. 2.Cable Manager Rotate the retainer to the vertical position
3. Pan Head Screw
Power supply instructions
WARNING! During the installation, ensure that AC power is NOT connected to the Power
Supply.
Power Supply Slots:
• While installing multiple power supplies in a switch, Hewlett Packard Enterprise
recommends that all power supplies are the same models.
• See the HPE 5400R zl2 Installation and Getting Started Guide for selecting the correct power
cord to use with the supply.
1. Remove the slot cover plate.
2. Align the power supply in the
switch slot and insert it until the
external wall of the power supply
is flush with the switch chassis.
3. Tighten the retaining screws to
secure the power supply to the
switch.
Power supply instructions 3
To Next Page
Loading...
