HP 6125XLG - Displaying and Maintaining TRILL

16
• GR helper—A neighbor of the GR restarter. It helps the GR restarter to complete the GR process.
To configure TRILL GR:
Step Command Remarks
1. Enter system view.
system-view N/A
2. Enter TRILL view.
trill N/A
3. Enable GR for TRILL.
graceful-restart By default, GR is disabled for TRILL.
4. (Optional.) Configure
the GR interval for TRILL.
graceful-restart interval
interval
The default setting is 300 seconds.
Displaying and maintaining TRILL
Execute the display commands in any view and the reset command in user view.
Task Command
Display TRILL ardency table
information.
display trill adjacent-table [ count | nickname nickname interface
interface-type interface-number ]
Display brief TRILL information. display trill brief
Display TRILL FIB information. display trill fib [ count | nickname nickname ]
Display TRILL GR status. display trill graceful-restart status
Display TRILL port information. display trill interface [ interface-type interface-number ]
Display TRILL LSDB information. display trill lsdb [ local | lsp-id lsp-id | verbose ] *
Display all ingress entries in the TRILL
multicast FIB (MFIB).
display trill mfib ingress [ vlan vlan-id [ local-entry | remote-entry ] ]
Display all egress entries in the TRILL
MFIB.
display trill mfib transit [ nickname nickname [ prune-entry | rpf-entry
| vlan vlan-id [ mac-address mac-address ] ] ]
Display information about the TRILL
multicast routing table.
display trill multicast-route [ tree-root nickname [ vlan vlan-list [ mac
mac-address ] ] ]
Display the TRILL neighbor table. display trill neighbor-table
Display the TRILL neighbor statistics. display trill peer [ interface interface-type interface-number ]
Display the TRILL RPF check table
information.
display trill rpf-table tree-root nickname
Display information about the TRILL
unicast routing table.
display trill unicast-route [ nickname nickname ] [ verbose ]
Clear dynamic running statistics of
the TRILL process.
reset trill