19
[RB6-FortyGigE1/0/4] trill link-type trunk
[RB6-FortyGigE1/0/4] quit
[RB6] interface fortygige 1/0/5
[RB6-FortyGigE1/0/5] trill enable
[RB6-FortyGigE1/0/5] trill link-type trunk
[RB6-FortyGigE1/0/5] quit
# Configure RB 7 through RB 9 in the same way RB 6 is configured.
4. Configure the uplink ports of the distribution layer devices:
# Enable TRILL on uplink ports FortyGigE 1/0/6 and FortyGigE 1/0/7 of RB 6.
[RB6] interface fortygige 1/0/6
[RB6-FortyGigE1/0/6] trill enable
[RB6-FortyGigE1/0/6] quit
[RB6] interface fortygige 1/0/7
[RB6-FortyGigE1/0/7] trill enable
[RB6-FortyGigE1/0/7] quit
# Configure RB 7 through RB 9 in the same way RB 6 is configured.
5. Configure TRILL distribution trees:
# Set the RB 6's priority to 65535, and set the number of TRILL distribution trees that the RB wants
all RBs to compute to 4.
[RB6] trill
[RB6-trill] tree-root priority 65535
[RB6-trill] trees calculate 4
[RB6-trill] quit
# Set the RB 7's priority to 65534, and set the number of TRILL distribution trees that the RB wants
all RBs to compute to 4.
[RB7] trill
[RB7-trill] tree-root priority 65534
[RB7-trill] trees calculate 4
[RB7-trill] quit
# Set the RB 8's priority to 65533, and set the number of TRILL distribution trees that the RB wants
all RBs to compute to 4.
[RB8] trill
[RB8-trill] tree-root priority 65533
[RB8-trill] trees calculate 4
[RB8-trill] quit
# Set the RB 9's priority to 65532, and set the number of TRILL distribution trees that the RB wants
all RBs to compute to 4.
[RB9] trill
[RB9-trill] tree-root priority 65532
[RB9-trill] trees calculate 4
[RB9-trill] quit
Verifying the configuration
Suppose that the nicknames of RB 1 through RB 9 are 0x5801 through 0x5809, respectively.
Use display trill unicast-route to display the TRILL unicast routing table. For example:
To Next Page
Loading...
