18
<RB1> system-view
[RB1] trill
[RB1-trill] quit
[RB1] interface ten-gigabitethernet 1/0/1
[RB1-Ten-GigabitEthernet 1/0/1] trill enable
[RB1-Ten-GigabitEthernet 1/0/1] quit
# Configure RB 2 through RB 5 in the same way RB 1 is configured.
2. Configure the uplink port of access layer devices:
# Enable TRILL on uplink port FortyGigE 1/1/1 through FortyGigE 1/1/4 of RB 1, and configure
these ports as trunk ports.
[RB1] interface fortygige 1/1/1
[RB1-FortyGigE1/1/1] trill enable
[RB1-FortyGigE1/1/1] trill link-type trunk
[RB1-FortyGigE1/1/1] quit
[RB1] interface fortygige 1/1/2
[RB1-FortyGigE1/1/2] trill enable
[RB1-FortyGigE1/1/2] trill link-type trunk
[RB1-FortyGigE1/1/2] quit
[RB1] interface fortygige 1/1/3
[RB1-FortyGigE1/1/3] trill enable
[RB1-FortyGigE1/1/3] trill link-type trunk
[RB1-FortyGigE1/1/3] quit
[RB1] interface fortygige 1/1/4
[RB1-FortyGigE1/1/4] trill enable
[RB1-FortyGigE1/1/4] trill link-type trunk
[RB1-FortyGigE1/1/4] quit
# Configure RB 2 through RB 5 in the same way RB 1 is configured.
3. Configure the downlink ports of distribution layer devices:
# Enable TRILL globally on RB 6, enable TRILL on downlink port FortyGigE 1/0/1 through
FortyGigE 1/0/5 of RB 6, and configure these ports as trunk ports.
<RB6> system-view
[RB6] trill
[RB6-trill] quit
[RB6] interface fortygige 1/0/1
[RB6-FortyGigE1/0/1] trill enable
[RB6-FortyGigE1/0/1] trill link-type trunk
[RB6-FortyGigE1/0/1] quit
[RB6] interface fortygige 1/0/2
[RB6-FortyGigE1/0/2] trill enable
[RB6-FortyGigE1/0/2] trill link-type trunk
[RB6-FortyGigE1/0/2] quit
[RB6] interface fortygige 1/0/3
[RB6-FortyGigE1/0/3] trill enable
[RB6-FortyGigE1/0/3] trill link-type trunk
[RB6-FortyGigE1/0/3] quit
[RB6] interface fortygige 1/0/4
[RB6-FortyGigE1/0/4] trill enable
To Next Page
Loading...
