HP Jetdirect EIO Control Panel Menus 38
ENWW
CFG TCP/IP= Selects whether you want to access the TCP/IP menu
and set TCP/IP protocol parameters.
NO (default): Bypass the TCP/IP menu items.
YES: Access the TCP/IP menu items.
TCP/IP menus depend on your print server model.
● BOOTP=YES* enables configuration by a BootP
server.
● DHCP=YES* enables configuration by a DHCP
server. If DHCP=YES* and the print server has
acquired a DHCP lease, you can choose to configure
the following DHCP settings:
■ RELEASE: Choose YES to release, or NO to save, the
current DHCP lease.
■ RENEW: Choose YES to renew the current DHCP lease,
or NO not to renew the DHCP lease.
● AUTO IP=YES* will configure a link-local address.
In these cases, manual configuration is turned off.
If you specify BOOTP=NO, DHCP=NO, you can
choose AUTO IP=YES to have a link-local address
169.254.x.x assigned automatically.
If BOOTP, DHCP and AUTO IP are disabled, you can
manually set the following TCP/IP parameters from the
control panel:
■ Each byte of the IP address (IP)
■ Subnet Mask (SM)
■ Syslog Server (LG)
■ Default Gateway (GW)
■ Idle Timeout period (default is 270 seconds, 0 disables
the timeout)
● (620n only) CFG DNS=YES* will allow you to
specify the IP address of a DNS server, one byte at
a time.
Print a Jetdirect configuration page to verify your
settings. However, note that the print server may
overwrite selected parameters with values that ensure
proper operation.
Table C-1. EIO Classic Control Panel Menu (2 of 3)
Menu Item Description
EIOSG.book Page 38 Thursday, October 9, 2003 1:42 PM
To Next Page
Loading...
