HP 6200

To Next Page

To Previous Page

The control panel display shows the wrong language

Solution

Usually, you set the language and country/region when you first set up the HP all-

in-one. However, you can change these settings at any time by using the following

procedure:

1 Press Setup.

2 Press 7, and then press 1.

This selects Preferences, and then selects Set Language & Country/Region.

A list of languages appears. You can scroll through the list of languages by

pressing the

and arrows.

3 When your language is highlighted, press OK.

4 When prompted, press 1 for Yes or 2 for No.

The countries/regions for the selected language appear. Press

or to

scroll through the list.

5 Use the keypad to enter the two-digit number for the appropriate country/

region.

6 When prompted, press 1 for Yes or 2 for No.

The wrong measurements are showing in menus on the control panel display

Solution

You may have selected the incorrect country/region when setting up your HP all-

in-one. The country/region you select determines the paper sizes shown on the

control panel display.

To change the country/region, you must first set the default language again.