14 Installing and troubleshooting
Changing the SCSI address
Changing the SCSI addressChanging the SCSI address
Changing the SCSI address
The address for the HP scanner is preset to 2. If you have other SCSI devices
attached to this SCSI card, you may need to change the scanner address to prevent
address conflicts. If this is the case, use the following procedure only AFTER
installing the scanning software.
To change the SCSI address
1 Find an available address using the documentation that came with the
computer. Do not choose the addresses for the SCSI card, typically 7, and the
hard disk drives, typically 0 or 1.
2 Press F
AX and FILE on the scanner at the same time. “SCSI Address: 2” should
appear on the front panel display.
3 Use the NUMBER OF COPIES button on the scanner to select a number for the
SCSI address. The number changes on the front panel display as you press the
button.
4 To exit the SCSI address settings, press any button on the scanner except the
NUMBER OF COPIES button.
To Next Page
Loading...