Figure
4-12.
Data
Processing
Flow
Diagram
Note
If
the
analyzer has
an
active
two-port
measurement
calibration,
all
four
S-parameters
will
be
saved
with
the
measurement
results
.
All
four
S-parameters
may
be
viewed
if
the
raw
data
array
has
been
saved.
1.
If
you
want
to
title
the
displayed
measurement,
refer
to
\Titling
the
Displayed
Measurement,"
located
earlier
in
this
chapter
.
2.
Press
4
SA
VE/RECALL
5
N
N
N
N
N
NN
NN
NN
NN
N
N
N
N
N
N
N
N
N
N
N
N
N
N
N
N
N
NN
NN
N
SELECT
DISK
.
3.
Choose
one
of
the
following
disk
drives:
N
N
N
N
N
N
N
N
N
NN
NN
NN
NN
N
N
N
N
N
N
N
N
N
N
N
N
N
N
N
N
N
NN
NN
NN
N
INTERNAL
DISK
N
NN
NN
NN
NN
NN
NN
N
N
N
N
N
N
N
N
N
N
N
NN
NN
NN
NN
NN
NN
NN
N
N
N
EXTERNAL
DISK
and
then
congure
as
follows:
a. Connect an external disk drive to the analyzer's HP-IB connector
, and congure as
follows:
b. Press
4
LOCAL
5
NNNN
NNNNNNNNNNNNNNNNNNNNNNNNN
NNNNNNNNNNNNNNNNNNNNN
DISK UNIT NUMBER
and enter the drive where your disk is located,
followed by
4
x1
5
.
c.
If your storage disk is
partitioned, press
NNNNNNNNNNNNN
NNNNNNNNNNNNNNNNNNNNNNNNN
NNN
VOLUME NUMBER
and enter the
volume number
where you want to store the instrument state le
.
d.
Press
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
SET ADDRESSES
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
ADDRESS: DISK
.
e. Enter the HP-IB address of the peripheral, if the default address is incorrect
(default = 00). Follow the entry by pressing
4
x1
5
.
Printing, Plotting, and Saving Measurement Results 4-37
To Next Page
Loading...
