HP 8756A - Page 83

Model 8756A
Operating Information
9. Connect the Detector input to the B input of the 8756A. On
the 8756A, press [PRESET] , Channel 1 [SHIFT] [MEAS RATIO]
(CHAN OFF) to turn Channel 2 off, and select Channel 1
[MEAS PWR] to B. Repeat Steps 6 through 8 for the B
Detector Input.
10. Connect the Detector input to the R input of the 8756A. On
the 8756A, press [PRESET] , Channel 1 [SHIFT] [MEAS RATIO]
(CHAN OFF) to turn Channel 2 off, and select Channel 1
[MEAS PWR] to R. Repeat Steps 6 through 8 for the R
Detector Input.
11. If any test fails, or Microwave Test Device measurements do
not reasonably match previous measurements, refer to the
Performance Tests in Section IV.
12. When finished with the Operator's Checks, reconnect the
8756A with the cabling configuration necessary for correct
operation with your Sweep Oscillator (the HP 8340A and
8350B require additional connections).
Figure 3-6. Operator's Check (5 of 5)
3-51/3-52