To Next Page

To Previous Page

8. Place the drive down into the drive bay, slide the drive forward (1), and then connect the cable to the

rear of the drive (2).

9. To replace the rear metal shield, slide the outer tabs on each side of the bottom of the shield under the

metal framework on the display head and the center tab on each side above the metal framework (1),

and then rotate the top of the shield onto the display head so that it snaps in place (2).

28 Chapter 2 Hardware upgrades

Questions and Answers:

Need help?

Do you have a question about the HP 9015 and is the answer not in the manual?

HP 9015 Specifications

General

Model	HP 9015
RAM	8GB DDR4 (varies by configuration)
Storage	256GB SSD
Graphics	Intel UHD Graphics
Ports	HDMI
Wireless	Bluetooth 5.0