EasyManuals Logo

HP 9015 User Manual

HP 9015
52 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #37 background imageLoading...
Page #37 background image
6. Remove the 2.5” drive if one is installed. Disconnect the cable from the rear of the drive (1), pull the arm
back at the rear of the drive (2), and then slide the drive back and lift it out of the drive bay (3).
7. To remove an M.2 storage device, remove the screw that secures the device to the system board (1) so
that the end pops up (2), and then slide the device out of the connector (3).
NOTE: Due to the small size of the screw, a magnetized screwdriver may be helpful to remove the
screw.
Removing and installing an M.2 storage device 31

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP 9015 and is the answer not in the manual?

HP 9015 Specifications

General IconGeneral
ModelHP 9015
RAM8GB DDR4 (varies by configuration)
Storage256GB SSD
GraphicsIntel UHD Graphics
PortsHDMI
WirelessBluetooth 5.0

Related product manuals