Power-switch assembly
1. Remove the following items:
●
Flatbed-unit assembly. See
Flatbed scanner assembly on page 96.
●
Lower flatbed ribbon guide. See
Power supply on page 99 (Step 4).
●
Right keyboard tray guide. See
Power supply on page 99 (Step 7).
2. Remove three screws (callout 1).
1
Figure 5-92 Removing the power-switch assembly
3. Remove the power-switch assembly.
NOTE: When reinstalling the power switch, make sure that the power-switch mechanism
is seated correctly and that the keyboard tray is seated into its guide before installing the
keyboard tray guide.
ENWW Internal components 105
To Next Page
Loading...
