ADF mylar shield
1. Remove the mylar-holder assembly. See Mylar-holder assembly on page 44.
2. Carefully unhook the mylar shield from the four tabs on the mylar-holder assembly, and then
remove and discard the mylar shield.
Figure 5-13 Replacing the ADF mylar shield (4 of 7)
3. Use a dry cloth to clean the white strips inside of the mylar-holder assembly.
4. Insert a new mylar shield, and clip it onto the four tabs on the mylar-holder assembly.
NOTE: Make sure that you do not leave fingerprints on the new mylar shield.
Figure 5-14 Replacing the ADF mylar shield (5 of 7)
46 Chapter 5 Removal and replacement ENWW
To Next Page
Loading...
