Hard-disk drive cables
WARNING! The product contains components that are sensitive to electrostatic discharge
(ESD). Always perform service work at an ESD-protected workstation. If an ESD-protected
workstation is not available, discharge body static by grasping the device chassis before touching
an ESD-sensitive component. Ground the device chassis before servicing the product.
1. Remove the formatter cage (see Formatter cage on page 49), open the formatter-cage door, and
then disconnect the hard-disk drive cables from the hard-disk drive (callout 1).
1
Figure 5-21 Removing the hard-disk drive cables (1 of 2)
2. Disconnect the hard-disk-drive cables from the formatter (callout 2).
2
Figure 5-22 Removing the hard-disk drive cables (2 of 2)
ENWW User-replaceable parts 51
To Next Page
Loading...
