• HP StorageWorks Encryption SAN Switch (Brocade BES)
• HP StorageWorks DC04 SAN Director (Brocade DCX-4S)
• HP StorageWorks DC SAN Backbone Director (Brocade DCX)
• HP StorageWorks SAN Director 16 Port 8-Gb FC Blade (Brocade FC8-16)
• HP StorageWorks SAN Director 32 Port 8-Gb FC Blade (Brocade FC8-32)
• HP StorageWorks SAN Director 48 Port 8-Gb FC Blade (Brocade FC8-48)
• HP StorageWorks SAN Director 6 Port 10-Gb FC ISL Blade (Brocade FC10-6)
• HP StorageWorks DC Switch Encryption FC Blade (Brocade FS8-18)
• HP StorageWorks EVA4400 Embedded Switch Module (Brocade 5410)
• Brocade 8-Gb SAN Switch for HP BladeSystem c-Class (Brocade 5480)
• HP StorageWorks 1606 Extension SAN Switch (Brocade 7800)
• HP StorageWorks 2408 FCoE Converged Network Switch (Brocade 8000)
• HP StorageWorks DC SAN Director Switch 10/24 FCoE Blade (Brocade FCOE10-24)
• HP StorageWorks DC SAN Director Multiprotocol Extension Blade (Brocade FX8-24)
Unsupported product models
Any product models not listed in “Supported product models” on page 10 do not support Fabric OS
6.3.x.
Devices supported
For a list of supported devices, see the HP website:
http://www.hp.com/go/san
Operating systems
For a list of operating systems, see the HP website:
http://www.hp.com/go/san
Access Gateway support
Access Gateway is supported with Fabric OS 6.3.x for the following HP products only:
• Brocade 8-Gb SAN Switch for HP BladeSystem c-Class (Brocade 5480)
• HP StorageWorks 8/24 SAN Switch (Brocade 300)
• HP StorageWorks 8/40 SAN Switch (Brocade 5100)
IMPORTANT:
Although the 8/8 SAN Switch uses the same hardware as the 8/24 SAN Switch, it does not support
Access Gateway because only the 8/24 switch has all ports licensed as required for Access Gateway
support. Similarly, for the 8/40 switch to support Access Gateway mode, all ports must be licensed.
Access Gateway connectivity is supported by the switches listed in this section and also by the following
B-series switches:
HP StorageWorks Fabric OS 6.3.0c Release Notes 11
To Next Page
Loading...
Need help?
General
