Do you have a question about the HP A5120 Series and is the answer not in the manual?
Device Type | Switch |
---|---|
MAC Address Table Size | 16K entries |
Product Series | HP A5120 |
Model | A5120 |
Switching Capacity | 128 Gbps |
Forwarding Rate | 95.2 Mpps |
Routing Protocol | Static, RIP, OSPF, BGP |
Management | CLI, Web, SNMP |
Operating Temperature | 0°C to 45°C |
Operating Humidity | 10% to 90% (noncondensing) |
Ports | 24 or 48 10/100/1000 ports |
VLANs | 4094 |
Dimensions (W x D x H) | 440 x 360 x 44 mm |
Installation and removal must be carried out by qualified personnel.
Read operation instructions and precautions carefully to minimize the possibility of accidents.
Lists symbols used in the manual for safety precautions.
Read all installation and safety instructions before installation or operation.
Do not block ventilation openings and maintain distance from walls.
Always make the ground connection first and disconnect it last.
Device is suitable for TN power systems, not IT power systems.
Reinforced insulation needed for DC supplied models between sources.
AC plug-socket combination must be accessible as main disconnecting device.
Do not connect SELV circuits to TNV circuits to avoid electric shock.
Never look at the transmit laser or fiber ports when powered on.
Improper controls/adjustments may cause hazardous laser emissions.
The separate earthing terminal must be permanently connected to earth.
High voltage safety precautions during installation.
Remove conductive items like watches and jewelry during installation.
If water is found in the rack, immediately switch off the power supply.
Power cord set must be UL approved and CSA certified for the country.
Lists various regulatory compliance standards for EMC and Safety.
Products comply with Low Voltage, EMC, and WEEE Directives.
Covers FCC, FDA, and ICES-003 compliance for USA and Canada.
Products comply with VCCI, CISPR, and CCC Class A requirements.
Information on proper disposal and recycling of waste electrical and electronic equipment.