Media Type : DISK
System Card Label :
System Card CID :
Remote EE Reachability :
Node WWN/Slot EE IP Addr EE State
IO Link State
10:00:00:05:1e:53:77:80/0 10.32.53.107 EE_STATE_ONLINE Non-Reachable
10:00:00:05:1e:53:b7:ae/0 10.32.53.105 EE_STATE_ONLINE Non-Reachable
• SKM FIPS Mode Enablement
FIPS compliance mode is disabled in SKM by default. To enable it, follow the procedure described
in the SKM user guide, “Configuring the Key Manager for FIPS Compliance” section.
NOTE:
Per FIPS requirements, you cannot enable or disable FIPS when there are keys on the Key Manager.
Therefore, if FIPS enablement is required, HP strongly recommends that it be performed during
the initial SKM configuration, before any key sharing between the switch and the SKM occurs.
Initial setup of encrypted LUNs
IMPORTANT:
While performing first-time encryption to a LUN with more than one initiator active at the time, rekey
operations slow to a standstill. Define LUNs for a single initiator at a time to avoid this occurrence.
NOTE:
When configuring multipath LUNs, care should be taken to add LUN 0 on all of the paths, subject to
the following considerations:
• If LUN 0 presented by the back-end target is a controller LUN (not a disk LUN; that is, not visible
in the discoverLUN output), add LUN 0 to the container as a clear text LUN. Make sure all of
the paths have this LUN 0 added for MPIO operation (EVA configuration, for example).
• If LUN 0 presented by the back-end target is a disk LUN, LUN 0 can be added to the container
either as clear text or encrypted (MSA configuration, for example).
• For HP-UX, LUN 0 can appear as 0x0 or 0x400, but both of them are LUN 0 only and should be
treated alike.
Fabric OS 6.3.0 fixes
Table 9 lists defects closed in the Fabric OS 6.3.0 firmware release. All fixes from Fabric OS 6.1.2b
and 6.2.0g are merged into the 6.3.0 release.
Table 9 Fabric OS 6.3.0 closed defects
SolutionClosed defect summary
HP StorageWorks Fabric OS 6.3.0c Release Notes 43
To Next Page
Loading...
