Fixed in Fabric OS 6.3.0
Node descriptors are missing for DC SAN Director and DC04 SAN
Director.
Fixed in Fabric OS 6.3.0
Tape pipelining code begins to randomly send only data frames in an
exchange to tape drive.
Fixed in Fabric OS 6.3.0
Partitioned DC04 SAN Director panicked after reset allegiance issued
by multiple hosts.
Fixed in Fabric OS 6.3.0
Rolling ASSERT+PANIC on DC SAN Director with DC Switch Encryption
blade faulty when going from 6.1.2 to 6.2.0d.
Fixed in Fabric OS 6.3.0
Portswap not working for ports 32-47 on 48 port blade.
Fixed in Fabric OS 6.3.0
VI to PT routes are deleted following portdisable and portenable
on a 48–port 4Gb blade.
Fixed in Fabric OS 6.3.0
2408 FCoE Converged Network switch freezes with jumbo frame
blast.
Fixed in Fabric OS 6.3.0
FDMI Database information not showing proper information after dis-
abling the port in AG that is connected to HBA.
Fixed in Fabric OS 6.3.0
Host with Fibrechannel Fastwrite (FCFW) enabled has problems with
port disable/enable of HBA ports.
Fixed in Fabric OS 6.3.0
Switch Kernel panics when performing VMware VMotion (vport migra-
tion).
Fixed in Fabric OS 6.3.0
While rekey operations are in progress, disrupting the I/O sync link
causes rekey operations to hang.
Fixed in Fabric OS 6.3.0
In an atypical test configuration, system reboot observed on one of
two 2408 FCoE Converged Network switches configured as point-to-
point FC connections.
Fixed in Fabric OS 6.3.0
Port Fencing - E_Port Class Link Resets are not fencing.
Fixed in Fabric OS 6.3.0
There is a small timing window that devices might send PLOGI earlier
than route is setup and cause PLOGI drop in single switch fabric.
Fixed in Fabric OS 6.3.0
2408 FCoE Converged Network switch has a rolling reboot when
deleting the active fcoe logincfg from conflicting logingroup database.
Fixed in Fabric OS 6.3.0
After rebooting one Encryption SAN Switch of a HAC that has con-
nectivity to the physical targets and initiators, all the crypto targets are
lost in the HAC cluster.
Fixed in Fabric OS 6.3.0
IPAD-5000 messages with error code "105" showing up on most
platforms in AG fabrics. Possible Memory Leak scenarios.
Fixed in Fabric OS 6.3.0
RLIRs with LOL is being generated on 8 Gb channels during CEC IML
Fixed in Fabric OS 6.3.0
Fail to label tape w/ error: ERROR, SYS, Crypto tape receives service
failure in tape_cmd_pre_execution_scsi_chk: PI BLK size > RBL, 0x0,
tape_util.c, line: 5002.
Fixed in Fabric OS 6.3.0
User entered FRU number via CLI is not being modified.
HP StorageWorks Fabric OS 6.3.0c Release Notes 49
To Next Page
Loading...
