39
The 8 Processor model comes in two flavors: one with one with 8 processors in a
single cabinet and one with 8 processors and one or two expander cabinets. In
either case, power for the processors is in the cabinet with the processor drawer.
1. Unpack and de-skid the system cabinets.
2. Roll the cabinets to the place the customer wants them located and
arrange them according to the cabinet placement rules for the given
system.
3. If necessary, follow the procedure for installing an expander cabinet.
4. Level the system using the four leveling feet at the bottom four corners of
the cabinet. Lower the leveling feet until the castor in each corner are free
to rotate and the feet, not the castors, support the weight of the cabinet.
At the rear of the cabinet you will find an extension bar with two non-load-
bearing leveling feet - they should be lowered until they make contact with
the floor.
5. Remove the orange shipping brackets and their screws; save them with
the system for use later should the system be moved.
6. There are two orange shipping brackets at the back that secure the I/O
drawers to the cabinet’s side rails. On each side, remove the brackets
and screws; save them with the system for use later should the system be
moved.
7. All cable connections should be made in a single cabinet system. Check
to make sure that cables are secure.
8. Connect to and set up the NAT box.
9. Connect the console.
10. Verify the installation.
To Next Page
Loading...
Need help?
General