19
Making the hardware connection:
1. Open the front door.
2. Unscrew the captive screw that holds the top cover to the frame.
3. Pull the top cover back and off the frame.
4. Unscrew the captive screw that holds the right side panel to the frame.
5. Lift the right side panel off the frame
6. Using a serial line cable, connect a PC/laptop to the serial line receptacle
now available on the bottom shelf.
7. Lay the cable on the shelf so that it exits the back of the tower.
8. Replace the side panel and cover.
Setting up the PC/laptop:
Baud rate = 9600
Byte size = 8 bit
Parity = none
To Next Page
Loading...
Need help?
General