21
Making the hardware connection:
1. Open the front door.
2. Unscrew the captive screw that holds the top cover to the frame.
3. Pull the top cover back and off the frame.
4. Unscrew the captive screw that holds the right side panel to the frame.
5. Lift the right side panel off the frame.
6. Using a BN24Q-xx cable, (a crossover network cable) connect an ethernet
card in an AlphaServer workstation running Tru64 UNIX to the MSB LAN
connection in the Tower.
7. Lay the cable on the shelf so that it exits the back of the tower.
8. Replace the side panel and cover.
If the customer intends to use the AlphaServer Management Station to control
multiple ES47 Towers or other ES and GS series systems, the following
additional hardware must be setup.
1. The LAN side of NAT box connected to the ES47 tower. See connect and
set-up a NAT box.
2. The WAN side of the NAT box connected to multi-server LAN HUB.
3. The AMS setup to point to the WAN side of the NAT box. See setup the
AMS on the MS LAN.
Setting up the AMS:
Assuming a direct connection from the AMS to the ES47 Tower:
1. Put the AMS on the corporate LAN. See setting up AMS to the corporate
LAN.
2. Point the AMS to the MBM internal LAN connection. To do this follow the
instructions for setting up the AMS on the MS LAN AND make the
following change to that procedure. In step 6, when configuring Tu1
change the IP address field from 90.0.0.2 to 10.253.0.254. Leave the
subnet mask 255.255.0.0
3. Install the AMS software using its installation and user documentation.
Refer to the AMS 1.1.0 CD for instructions on installing and using the
AlphaServer Management Station (AMS) from an AlphaServer workstation
running Tru64 UNIX.
To Next Page
Loading...
Need help?
General