37
The ES80 comes in a single cabinet with three or four 2P drawers.
1. Unpack and de-skid the system.
2. Roll the cabinet to the desired location.
3. Level the system using the four leveling feet at the bottom four corners of
the cabinet. Lower the leveling feet until the castor in each corner are free
to rotate and the feet, not the castors, support the weight of the cabinet.
At the rear of each cabinet you will find an extension bar with two non-
load-bearing leveling feet - they should be lowered until they make contact
with the floor.
4. All cable connections should be made in a single cabinet system. Check
to make sure that cables are secure.
5. There are two shipping brackets at the front that secure the 2P drawers to
the cabinet’s side rails. On each side, remove the screw that secures the
drawer to the bracket.
6. There are two orange shipping brackets at the back that secure the I/O
drawers to the cabinet’s side rails. On each side, remove the brackets
and screws; save them with the system for use later should the system be
moved.
7. Under normal circumstances an expander cabinet does not come with this
system, however, should one arrive, place the cabinet to the right of the
system cabinet and follow the procedure for installing an expander
cabinet.
8. Connect and set up the NAT box.
9. Connect the console.
10. Verify the installation.
To Next Page
Loading...
Need help?
General