EasyManuals Logo

HP AlphaServer ES80 Installation Information

HP AlphaServer ES80
94 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #48 background imageLoading...
Page #48 background image
54
NAT box Installation Procedure
1. Using a BN25G-xx (RJ45) cable connect your PC to any LAN port on the
front of the NAT box in the system.
2. Make sure or configure your PC network connection is set to DHCP.
1. Click the start button, select settings, and Network and Dial-up
Connections
2. Select local area connections and click on properties.
3. Select Internet Protocol (TCP/IP) and click on properties.
4. Verify or configure the adaptor to Obtain an IP address
automatically.
5. Click the OK button.
6. Verify that the NAT box has provided your PC with an IP address. You
can see this by bringing up a DOS window and issuing the ipconfig
command.
The address given by the NAT box should be 196.168.2.xx. If you do
not get this address, with a pen or pencil press and hold reset button
on the front of the box.
3. Configuring the NAT box.
Setting up the LAN side of the box
Bring up an Internet Explorer window on the PC and target the NAT box.
Use the IP address given as the Default Gateway by the NAT box (this is

Other manuals for HP AlphaServer ES80

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP AlphaServer ES80 and is the answer not in the manual?

HP AlphaServer ES80 Specifications

General IconGeneral
BrandHP
ModelAlphaServer ES80
CategoryServer
LanguageEnglish

Related product manuals