HP AlphaServer ES80 Installation Information

67
With the advent of partitions and complex computer room environments,
traditional single consoles for each system and partition are becoming obsolete.
These systems use an internal LAN for server management operations like
booting and configuring the system environment. There are several ways to
connect consoles to the system. There are three LANs to consider: the internal
LAN in the system, the multi-server LAN, and the corporate LAN. You should
work with the customer to decide how the console(s) should be connected.
Connect a PC to the NAT Box
1. Using a BN25G-xx cable connect a PC/laptop to the WAN side of the
NAT box.
2. When you set up the NAT box you establish a network address for the
WAN side of the NAT box. If you followed the directions, the WAN side of
the NAT box has an address of 90.0.100.1
3. Start a telnet session on your PC to address <nat box address>:23 (23 is
the PMUs port address)
4. The MBM> prompt should appear on your PC.
Using this console you can manage the system using Telnet or the AlphaServer
Management Utility. Refer to the AMS 1.1.0 CD for instructions on installing and
using the AlphaServer Management Utility (AMU) from a PC running Windows.
Connect a AlphaServer management Station
1. Set up the NAT box between the internal LAN and the multi-server LAN.
2. Use the second BX25G-xx cable to connect the NAT box’s WAN
connection to the HUB set up for the multi-server LAN.
3. Set up the AMS on the multi-server LAN.
4. Install the AMS software. Refer to the AMS 1.1.0 CD for instructions on
installing and using the AlphaServer Management Station (AMS) from an
AlphaServer workstation running Tru64 UNIX.
Connect the corporate LAN to the AMS
1. Set up the NAT box between the internal LAN and the multi-server LAN.
2. Use the second BX25G-xx cable to connect the NAT box’s WAN
connection to the HUB set up for the multi-server LAN.
3. Set up the AMS on the multi-server LAN.
4. Set up the AMS on the corporate LAN.
5. Install the AMS software. Refer to the AMS 1.1.0 CD for instructions on
installing and using the AlphaServer Management Station (AMS) from an
AlphaServer workstation running Tru64 UNIX.
Connect from the corporate LAN to the internal LAN
1. Setup the NAT a box between the internal LAN and the corporate LAN.
2. Start a telnet session on your PC to address <nat box address>:23 (23 is
the PMUs port address)
3. The MBM> prompt should appear on your PC connected to the corporate

HP AlphaServer ES80 Specifications

General

Brand	HP
Model	AlphaServer ES80
Category	Server
Language	English