TAG 099: +24 Vdc Power Shorted
3-100 Troubleshooting Analysis Guide (TAGs) June 1999
36
Turn the printer off.
• Reconnect J/P317.
• Disconnect J/P308 and J/P309.
• Turn the printer on.
• Check J/P330-1 for +24 Vdc.
Is the voltage +24 Vdc?
No: Repair the duplex control board #1, then turn to TAG 002: Check & Problem Resolution.
Yes: Repair or replace the connectors or wiring from:
P309 pins 7 through 10 to J313 pins 1 through 4
P308-1 to J314-1
P308-2 to J315-1
P308-3 to J316-1, or
P308-4 to P317-1;
then turn to TAG 002: Check & Problem Resolution.
To Next Page
Loading...