HP C30 - Back Cover Removal

Back Cover Removal
7-6 Removal/Replacement Procedures June 1999
Back Cover Removal
To remove the back cover:
1 Remove all external cables and attachments.
2 Open the top and back covers.
3 Disconnect CN31, CN32, CN37, CN40, CN41, CN74, and CN91.
4 Duplex only: Disconnect CN36.
5 For the hard drive option, disconnect the drive’s data cable.
6 Remove the ground screw from the back cover.
7 While supporting the back cover, remove the screw holding each strap.
Caution: hold the plastic strap to avoid throwing the screw as it comes loose.
8 Lift the back cover up and away from the printer.
CN36
(C30D only)
CN37
CN40
CN41
CN33
CN91
Hard Disk Drive
Connector
CN32
CN31
CN74
Ground
Screw