Top Cover Hinge Removal
7-16 Removal/Replacement Procedures June 1999
Top Cover Hinge Removal
To remove the top cover hinge:
1 Open the top cover.
2 Remove the two screws holding the hinge/support to the top cover.
3 Remove the two screws holding the hinge/support to the printer base.
4 While supporting the top cover, loosen the top two screws.
5 Remove the hinge.
Replacement Note:
Replace one hinge at a time so that one always remains in place to support the top cover.
Loosen Screws
Hinge Detail
To Next Page
Loading...