Fuser Drive Belt Removal
June 1999 Removal/Replacement Procedures 7-57
Fuser Drive Belt Removal
To remove the fuser drive belt:
1 Open the back cover.
2 Remove the fuser drive cover (three screws).
3 Remove the main drive cover (one screw).
4 Remove the gear stay cover (one screw).
5 Remove the gear stay (three screws).
6 Remove the main drive gear and bearing (single C-clip).
7 Remove the single upper left screw and the two lower screws holding the fuser drive
in place.
8 Loosen the upper right screw for the fuser drive and pivot the drive down.
9 Slide the fuser drive belt off the gear.
Loosen
Main Motor
Fuser Drive Cover
Gear Stay
Gear Stay
Main Drive
Screw
Gear
Cover
Cover
To Next Page
Loading...