HP C30 - Exit Pinch Roller Removal

Exit Pinch Roller Removal
June 1999 Removal/Replacement Procedures 7-69
Exit Pinch Roller Removal
To remove the exit pinch roller:
1 Open the front, back, and top covers.
2 Remove the fuser.
3 Remove the operator panel (see page 7-19).
4 Remove the front screw holding the exit pinch roller in place.
5 Remove the front screw holding the exit guide in place.
Exit Pinch Roller Screw
C-Clip and Bearing
Exit Guide Screw
Front Detail