Paper Exit Sensor Removal
June 1999 Removal/Replacement Procedures 7-79
Paper Exit Sensor Removal
To remove the paper exit sensor:
1 Open the front, back, and top covers.
2 Remove the fuser.
3 Remove the operator panel (see page 7-19).
4 Remove the exit pinch roller (see page 7-69).
5 Disconnect CN49.
6 Remove the two screws holding the exit cover in place (one front and one back).
7 Tilt the exit cover assembly toward the center of the printer.
8 From the underside, remove the paper exit sensor (single screw).
CN49
Paper Exit Sensor Detail
To Next Page
Loading...