HP C30 - Paper Full Sensor Removal

Paper Full Sensor Removal
7-80 Removal/Replacement Procedures June 1999
Paper Full Sensor Removal
To remove the paper full sensor:
1 Open the front, back, and top covers.
2 Remove the fuser.
3 Remove the operator panel (see page 7-19).
4 Remove the exit pinch roller (see page 7-69).
5 Disconnect CN51.
6 Remove the two screws holding the exit cover in place (one front and one back).
7 Tilt the exit cover toward the center of the printer.
8 From the underside, remove the paper full sensor (single screw).
CN51
Paper Full Sensor Detail