HP C30 - Main Motor Removal

Main Motor Removal
June 1999 Removal/Replacement Procedures 7-87
Main Motor Removal
To remove the main motor:
1 Disconnect all external cables and attachments.
2 Open the front, back, and top covers.
3 Remove the photoconductor and place it in its protective packaging.
4 Remove the cleaner unit.
5 Remove the back cover (see page 7-6).
6 Remove the lower back cover (see page 7-7).
7 Remove the signal interface board (see page 7-37).
Do not allow the capacitor contacts to short out against your
Caution
body or the printer frame.
Fuser Drive Cover
Gear Stay
Gear Stay Cover
Main Drive Cover
Drive Shaft Key
Main Motor Gear
Back Detail