Duplex Control Board #1 Removal
7-90 Removal/Replacement Procedures June 1999
Duplex Control Board #1 Removal
To remove duplex control board #1:
1 Open the top cover.
2 Remove the duplex control board cover (two screws).
3 Disconnect CN306, CN307, CN308, and CN309.
4 Disengage duplex control board #1. To do this, pinch the four standoffs on the board
one at a time.
5 Lift the board from the mounting bracket.
CN308
CN309
CN306
CN307
Standoffs
Duplex Control Board Cover
Duplex Control Board #1 Detail
To Next Page
Loading...