HP C30 - B Roller Removal

“B” Roller Removal
7-98 Removal/Replacement Procedures June 1999
“B” Roller Removal
To remove the “B” roller:
1 Open the top cover.
2 Remove the rear duplex cover (see page 7-17).
3 Remove the upper duplex roller cover (four screws).
4 Remove the lower duplex roller cover (four screws).
5 Remove the front C-clip and bearing from the “B” roller.
6 Remove two screws holding the duplex control board cover in place.
7 Move the cover to the left out of the way.
8 Loosen the screw holding the idler roller in place.
9 Remove the duplex drive belt.
10 Remove the drive gear (single C-clip).
11 Slide the “B” roller out from the back of the printer.
B Roller
Drive Gear
Loosen Screw
Duplex
Drive Belt
Side Detail
Upper Duplex
Roller Cover
Lower Duplex
Roller Cover
Duplex Control
Board Cover
C-Clip and
Bearing