TAG 026: Paper in Output Area Before Printing
3-42 Troubleshooting Analysis Guide (TAGs) June 1999
TAG 026: Paper in Output Area Before Printing
Error Code: 026
Possible Defects: Exit paper sensor
PCL board
Connectors or wiring
If the printer has a high capacity output unit (HCO), unplug and remove it before begin-
ning this TAG. Test the printer without the HCO; if the problem remains, proceed with this
TAG. If the problem occurs only with the HCO, the HCO is causing the problem. Repair or
replace the HCO.
1
Turn the printer off and unplug the power cord.
• Check the paper path and remove any paper jams.
• Confirm that J/P50 and J/P40 are connected properly.
• Inspect the exit paper sensor actuator for damage or binding.
Is it in good working order?
No: Replace the exit paper sensor actuator and continue.
Yes: Continue.
2
Power-on-reset the printer.
Is error code 026 displayed?
No: Jammed paper, loose connectors, or sensor actuator were at fault; go to TAG 002: Check
& Problem Resolution.
Yes: Continue.
3
Check J/P40-26 for +12 Vdc.
Is the voltage +12 Vdc?
No: Replace the PCL board, then turn to TAG 002: Check & Problem Resolution.
Yes: Continue
4
Turn off the printer and unplug the power cord.
• Remove the exit cover.
• Disconnect J/P49 and J/P40.
• Check the following for continuity:
P40-26 to P49-1,
P40-24 to P49-2, and
P40-13 to P49-3
Is there continuity?
No: Repair or replace the connectors or wiring from:
P40-26 to J/P50-1 to P49-1,
P40-24 to J/P50-2 to P49-2, or
P40-13 to J/P50-3 to P49-3.
Then turn to TAG 002: Check & Problem Resolution.
Yes: Replace the exit paper sensor. If this doesn’t resolve the problem, replace the PCL board.
Then turn to TAG 002: Check & Problem Resolution.
To Next Page
Loading...