6. Select an option based on how the product will be connected to the computer.
Figure 3-11 Software Installation — Device Connection screen
●
Connect directly to the computer: Select this option and then click the Install button if the
product will be connected to the computer using a USB cable. Once the software is installed,
the Driver Installation Complete screen appears.
NOTE: If you choose this option, the printer should not be connected to the computer until
prompted during the installation process.
-or-
●
Connect via the network: Select this option if the product will be connected to the computer
using a network cable.
◦
If the product's networking settings are known, you can enter either the Host Name, IP
Address, or the Hardware Address, and then click the Install button. Once the software
is installed, the Driver Installation Complete screen appears.
◦
If the product's network settings are not known, click the Help me find my device on
the network button. A Discovery in Progress window appears. After the computer
searches the network, the Devices Found screen appears.
84 Chapter 3 Install Windows printing-system components ENWW
To Next Page
Loading...
