Job Storage tab features
NOTE: The Job Storage tab is located on the Printing Preferences tab set. For information about
how to access these tabs, see
Printing Preferences driver tabs on page 139.
Use the job-storage feature to store print jobs in the HP Color LaserJet CM6030 and CM6040 MFP
Series product memory or hard disk for printing at a later time.
The Job Storage tab appears among the driver tabs only if the job-storage feature is enabled on the
Device Settings tab. To support job-storage features for complex jobs, or if you often print complex
graphics, print postscript (PS) documents, or use many downloaded fonts, HP recommends that you
install additional memory, install a hard disk, or both. Added memory also gives you more flexibility in
supporting job-storage features. A minimum total memory of 288 MB is required to use the Proof and
Hold and Personal Job job-storage features. A hard disk is required to use the Quick Copy and Stored
Job job-storage features.
NOTE: This product comes with a hard disk installed on all models of the product.
There are four Job Storage Mode settings:
●
Proof and Hold
●
Personal Job
●
Quick Copy
●
Stored Job
The following figure shows the Job Storage tab.
ENWW Job Storage tab features 179
HP PCL 6 Print Driver for
Windows
To Next Page
Loading...
