208 Removal and replacement C7085-90921
Cam shafts
To remove the cam shafts
1 Remove the HVPS.
2 Remove the left side cover.
3 Remove the ITB drawer.
4 Open the drum drawer and remove the drum cartridge.
5 Remove the appropriate clutch or gear on the left side.
6 Using needle-nose pliers, remove the e-rings from each end of the shaft being removed.
7 Remove the bushings.
8 Remove the shaft.
Note If the shaft is undamaged, then only the cams need to be replaced. Remove the screw from the cam
and replace only the cam.
Figure 6-73 Cam shaft removal and replacement
To Next Page
Loading...