224 Troubleshooting C7085-90921
REMOVE PAPER TOP OUTPUT BIN
Description:
The top output bin holds 250 sheets of paper. Sensor PS9
(see Figure 7-21) along with its sensor flag detects the
height of the output paper stack. Perform the action items if
this message appears with no paper in the output bin.
Action:
1. Verify that the PS9 sensor flag and arm move freely and
its movement is not blocked (see Figure 7-21).
2. Verify PS9 is free of dust and debris (top assembly
cover must be removed to access sensor).
3. Verify all connectors are firmly seated. Refer to the
wiring diagram.
Note PS9 (a three-wire sensor) plugs into a through-wall connector on the printer’s chassis and then into a
14-pin wire harness, which plugs into J206 on the developing PCB (see Figure 7-21). All signals from
the developing PCB are routed to J201 on the developing PCB to J1017 on the DC controller PCB.
RESETTING MEMORY
Description:
The printer is executing a memory reset. The printer returns
to the
READY state upon completion of this process.
Action:
No action required.
RESETTING VALUES
FINISHED
Description:
The color calibration density values have been reset to their
default values.
Action:
No action required.
RESTORING FACTORY SETTINGS
Description:
The printer is executing a
RESTORE FACTORY SETTINGS
or a
COLD RESET.
Action:
No action required.
SELECT LANGUAGE
Description:
The language selection power-up key sequence has been
entered. The printer will prompt the user to select a new
control panel display language once it has completed its
initialization process.
Action:
Select new language when prompted.
SERVICE MODE
Description:
The Service Mode power-up key sequence has been
entered. The printer will remain in Service Mode until [Go] is
pressed.
Action:
Press [Go] to end Service Mode.
TONER CMYK LOW
Description:
The toner cartridge specified is low on toner. This message
appears if
TONER=LOW (default) is set on the printer control
panel in the Configuration Menu.
Action:
Printing will continue until a
TONER OUT message appears.
To change the toner cartridge now, press [Select].
TONER CMYK OUT
alternates with
PRESS SELECT TO CHANGE TONER
Description:
The toner cartridge specified is out of toner.
Action:
Press [Select] to enter the toner replacement mode. Press
[Go] to resume printing without changing the cartridge.
TONER CMYK LOW
alternates with
PRESS SELECT TO CHANGE TONER
Description:
The toner cartridge specified is low on toner and must be
replaced. This message appears when
TONER LOW =
STOP is set on the front panel in the Configuration Menu.
Action:
Press [Select] to enter the toner replacement menu.
Table 7-2 Alphabetical printer error messages (continued)
To Next Page
Loading...