HP color laserJet 4550 series - Page 227

C7085-90921 Chapter 7 Troubleshooting 225
TONER POSITION [COLOR] = [STATE]
Description:
Indicates the current state of a particular toner cartridge.
This message appears when [Select] is pressed while a
TONER LOW/OUT message appears.
Action:
If necessary, replace the specified toner cartridge.
TRANSFER KIT LOW
REPLACE KIT (4500)
-or-
TRANSFER KIT LOW
ORDER KIT (4550)
Description:
The transfer kit is near the end of its expected life.
Action:
Continue printing and order Transfer kit. The transfer kit will
need to be replaced when the message Transfer Kit Out is
displayed.
TRANSFER KIT OUT
REPLACE KIT
Description:
The transfer kit has reached the end of its expected life.
Action:
Replace the transfer kit.
TRAY X EMPTY
[TYPE] [SIZE]
Description:
The specified tray is empty but the current job does not
require this tray to complete the job.
Action:
No action required. However, loading the proper media type
and size into the tray will avoid this message in the future.
TRAY X LOAD
[TYPE] [SIZE]
Description:
The specified media type and size need to be loaded into the
requested tray.
Action:
Load the specified media type and size into the requested
tray. Press [Go] to override this request and cause the page
to be printed on different media.
TRAY X SIZE
[SIZE]
Description:
Media has been loaded into the specified tray. The most
recently configured size will be displayed with an asterisk
next to it.
Action:
1. [– Value +] might be used to view all possible media
sizes.
2. Pressing [Select] will select the currently displayed size.
Pressing [Go] will remove the message.
TRAY X TYPE
[TYPE]
Description:
Media has been loaded into the specified tray. The most
recently configured type will be displayed with an asterisk
next to it.
Action:
1. [– Value +] might be used to view all possible media
types.
2. Pressing [Select] will select the currently displayed
type. Pressing [Go] will remove the message.
TRAY X OPEN
Description:
The specified tray is not completely closed.
Action:
Close the specified tray.
WARMING UP
Description:
The fuser is warming up. Printing will continue when the
fuser reaches the optimum temperature.
Action:
No action required.
WASTE TONER FULL
REPLACE DRUM KIT
Table 7-2 Alphabetical printer error messages (continued)