C7085-90921 Chapter 3 Installation and configuration 59
Connecting a parallel cable
1 Press the printer standby button (power switch) to place the printer
in standby mode. Turn off the computer.
2 Plug the parallel cable into the printer’s parallel port until it snaps
into place.
3 Plug the other end of the parallel cable into the computer. Tighten
the screws on the parallel cable to secure the cable to the computer.
4 Turn the computer on and then turn the printer on.
Note
Your system will sense the printer (if your system is Plug and Play
compatible). Follow the directions on your screen. To install the
complete software package, cancel Plug and Play, and see the getting
started guide for more information.
3
4
2
1
To Next Page
Loading...