C7085-90921 Chapter 4 Printer maintenance 89
Replacing the transfer kit
Replace the transfer kit when the printer control panel displays:
TRANSFER KIT OUT REPLACE KIT.
The transfer kit consists of an intermediate transfer belt (ITB), a transfer
roller, two air filters, and a hand wipe.
1 Open the ITB drawer. Remove the used transfer belt by pulling up
on the green handles located on the sides.
2 Locate the transfer roller inside the printer.
3 To unlock the used transfer roller, gently push back and up (in a
rotating motion) on the blue triangles located on the lower corners
of the flap that is in front of the roller.
4 Remove the used transfer roller by lifting it up and then out.
1
2
3
4
To Next Page
Loading...