C9660-90901 Chapter 1 Printer description 23
Site requirements
The printer must be kept in a proper location to maintain the performance level that has been set at
the factory. In particular, be sure that the environment adheres to the specifications listed in this
chapter.
Below are recommendations for the printer location and placement.
Make sure the printer has the following:
● a well-ventilated, dust-free area
● a hard, level surface (not more than a 2° angle):
• for the HP Color LaserJet 4600, 4600n, and 4600dn, the surface must support 37 kg (81 lb)
• for the HP Color LaserJet 4600dtn and 4600hdn, the surface must support 44 kg (97 lb)
● a level surface that supports all four corners of the 500-sheet paper feeder
● a constant temperature and humidity. (Do not install near water sources, humidifiers, air
conditioners, refrigerators, or other major appliances)
Make sure to keep the printer away from the following:
● direct sunlight, dust, open flames, or water
● the direct flow of exhaust from air ventilation systems
● magnets and devices that emit a magnetic field
● areas subject to vibration
● walls or other objects. There must be enough space around the printer for proper access and
ventilation. See Figure 1-4 on page 23.
Space requirements
The printer must have the following amounts of space above and around it.
Figure 1-4 Space requirements
1 530 mm (20.9 inches)
2 1294 mm (50 inches)
3 804 mm (31.7 inches)
1
2
3
To Next Page
Loading...
