HP Color LaserJet 4700 - Page 204

Control panel message Description Recommended action
40 EIO X BAD
TRANSMISSION
To continue press
A connection with the card in EIO slot X
has been broken.
1 Press to continue printing.
NOTE A loss of data will
occur.
2 If the message persists, contact
HP Support at
http://www.hp.com/
support/clj4700.
40 EMBEDDED I/O BAD
TRANSMISSION
alternates with
To continue press
A connection with the embedded JetDirect
print server has been broken.
Turn the printer off then on. Press for
more information.
If the message persists, contact
HP Support at
http://www.hp.com/support/
clj4700.
41.3 UNEXPECTED
SIZE IN TRAY X
For help press
alternates with
LOAD TRAY XX
[TYPE] [SIZE]
To use another
tray press
Media is loaded that is longer or shorter in
the feed direction than the size configured
for the tray.
1 If the incorrect size was selected,
cancel the job or press
to access help.
OR
2 Press
to select another tray.
3 Press
and to step through the
instructions.
41.5 UNEXPECTED
TYPE IN TRAY X
For help press
alternates with
LOAD TRAY XX
[TYPE] [SIZE]
To use another
tray press
The printer senses a different media type in
the media path than configured in the tray.
1 If the incorrect type was selected,
cancel the job or press
to access help.
OR
2 Press
to select another tray.
3 Press
and to step through the
instructions.
44.1 USB ACCESSORY
ERROR
For help press
This message appears when a connected
USB accessory draws too much power.
When this happens, the ACC port is
disabled and printing stops.
Press to see step by step information.
49.XXXX
PRINTER ERROR
To continue
turn off then on
A critical firmware error has occurred. 1 Turn the printer off then on.
2 If the message persists, contact
HP Support at
http://www.hp.com/
support/clj4700.
188 Chapter 8 Problem solving ENWW